8
MIDI FOOT CONTROLLER FCB1010
1.3.2 Rear panel
Fig. 1.2: Rear panel connectors
FUSE HOLDER / VOLTAGE SELECTOR. Please make sure that your local voltage matches the voltage
indicated on the unit, before you attempt to connect and operate the FCB1010. Blown fuses may only
be replaced by fuses of the same type and rating. Some models allow for inserting the fuse holder in two
different positions, in order to switch over from 230-V to 115-V operation, and vice versa. Please note
that for 115-V operation outside Europe, you need to use a fuse of a higher rating (see chapter 3
INSTALLATION).
8
IEC POWER CONNECTOR. Use the enclosed power cord to connect the unit to the mains.
9
POWER switch. Use this switch to switch the FCB1010 on or off.
10
SERIAL NUMBER. Please take the time to have the warranty card filled out completely, and return it
within 14 days after the date of purchase, so as to be entitled to benefit from our extended warranty. Or
use our online registration option available on the World Wide Web under www.behringer.com.
11
SWITCHES 1 and 2. Use these jacks to connect your amplifier for channel selection (mono or stereo
phone jack cable).
12
MIDI IN. The MIDI IN of your FCB1010 connects to a sequencer or similar device, in order to download
the memory data saved before with the help of the MIDI SysEx function. Additionally, data can be looped
through the FCB1010 and merged with other data using the MIDI MERGE function. Subsequently, the
combined data are available at the MIDI OUT/THRU connector.
13
MIDI OUT/THRU. Use this jack to connect the devices you wish to control from your FCB1010. The
SOFT THRU circuit allows you to loop through any signals present at the MIDI IN of your FCB1010,
merge them with the units own data stream, and finally output the combined data at the MIDI OUT.
2. PROGRAMMING THE FCB1010
In this chapter you will learn to program your FCB1010 and adapt it to your specific MIDI set-up. But dont
worry, you wont have to learn a programming language before you could give your FCB1010 a single MIDI
command. The unit will perform all functions for you, one after the other. Simply make and confirm your
choices. If particular functions prompt you to enter a parameter, this will be covered specifically. Lets begin
with...
2.1 Selecting BANKS and PRESETS
There are two options to select a BANK and the PRESETS it contains. Which one you use depends on the
DIRECT SELECT parameter in the GLOBAL SETUP menu. If DIRECT SELECT is on, you can use the PRESET
foot switches to directly select the BANK number followed by the PRESET number. If DIRECT SELECT is off,
you need to step through the various BANKS (using the UP/DOWN switches), then select a PRESET from a
bank. The default setting is OFF. The illustrations below show the two options.
Lets assume you wish to select PRESET #1 from BANK #3...
2. PROGRAMMING THE FCB1010
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern