Behringer PROMIC2200 Bedienungsanleitung PDF herunterladen (Seite 12)

ULTRAGAIN PRO MIC2200

3.1 Rack mounting

The BEHRINGER ULTRAGAIN PRO fits into one standard 19" rack unit of space (1 3/4"). Please allow at least

an additional 4" depth for the connectors on the back panel. Be sure that there is enough air space around the

unit for cooling and please do not place the ULTRAGAIN PRO on high temperature devices such as power

amplifiers etc. to avoid overheating.

3.2 Mains voltage

Before you connect your ULTRAGAIN PRO to the mains, please make sure that your local voltage

matches the voltage required by the unit! The fuse holder on the female mains connector has 3 triangular

markers, with two of these triangles opposing each other. Your ULTRAGAIN PRO is set to the operating

voltage printed next to these markers, and can be set to another voltage by turning the fuse holder by 180°.

CAUTION: this instruction does not apply to export models exclusively designed, e.g. for 115 V op-

eration!

+ Please refer to the specifications for detailed information about specific voltage supplies!

3.3 Audio connections

The audio inputs and outputs on the BEHRINGER ULTRAGAIN PRO are fully balanced. If possible, connect

the unit to other devices in a balanced configuration to allow for maximum interference immunity.

+ Please ensure that only qualified persons install and operate the ULTRAGAIN PRO. During

installation and operation the user must have sufficient electrical contact to earth. Electro-

static charges might affect the operation of the ULTRAGAIN PRO!

Unbalanced use of

mono 1/4" jack plugs

Ring

Balanced use of

stereo 1/4" jack plugs

Balanced use with XLR connectors

1 2

2 1

Input

Output

Tip =

Signal

Tip =

hot (+ve)

Sleeve =

Ground / Shield

Sleeve =

Ground / Shield

Tip

Sleeve

Strain relief clamp

Ring =

cold (-ve)

For connection of balanced and

unbalanced plugs, ring and sleeve have

to be bridged at the stereo plug.

1 = Ground / Shield

2 = hot (+ve)

3 = cold (-ve)

For unbalanced use pin 1 and pin 3 have to be bridged

Fig. 3.1: Different plug types

3. INSTALLATION

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Behringer PROMIC2200 Bedienungsanleitung Seite 12

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Zusätzliche Musikausrüstung Behringer PROMIC2200